Neue GHCS601SS Manual do Utilizador descarregar pdf (Página 7)

4. Assemble the parts, follow the same procedure

backwards.

5. Replace the rating plate (it is near the gas supply

pipe) with the one for the new type of gas supply.

You can find this plate in the package supplied with

the appliance.

If the supply gas pressure is changeable or different

from the necessary pressure, you must fit an applicable

pressure adjuster on the gas supply pipe.

Adjustment of minimum level

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob and the gasket.

4. With a thin screwdriver, adjust the bypass screw

position (A).

5. If you change:

• from natural gas G20 20 mbar to liquid gas,

fully tighten the bypass screw in.

• from liquid gas to natural gas G20 20 mbar,

undo the bypass screw approximately 1/4 of a

turn (1/2 of a turn for Multi Crown burner).

6. Reassemble the gasket and the knob.

Warning! Make sure the flame does not

go out when you quickly turn the knob

from the maximum position to the

minimum position.

Electrical connection

• Do not pull the mains cable to disconnect the

appliance. Always pull the mains plug (if applicable).

• The appliance must not be connected with an

extension cable, an adapter or a multiple socket.

There is a risk of fire.

• Do not let the power cable to heat up to a

temperature of more than 90° C. The cable should

be guided by means of clamps fixed to the side of

the cabinet, in order to avoid any contact with the

appliance beneath the cooktop.

• Make sure that there is access to the mains plug

after the installation.

Electrical Requirements

Permanent electrical installation must agree with the

latest I.E.E. Regulations and local Electricity Board

regulations. For your own safety the installation must be

done by a qualified electrician (e.g. your local Electricity

Board, or a contractor who is on the roll of the National

Inspection Council for Electrical Installation Contracting

[NICEIC]).

The manufacturer refuses to be held

responsible, if these safety measures

are not abided by.

Supply connections

This hob has to be connected to 220-240 V (~ 50/60

Hz ) electricity supply.

The hob has a terminal block which is marked as

follows:

• L — Live terminal

• N — Neutral terminal

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Comentários a estes Manuais

Sem comentários

Neue GHCS601SS Manual do Utilizador Página 7

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Neue GHCS601SS